ENVIRONMENTAL RELEASES

This subsection presents the results of a life-cycle analysis of emissions. The bases are the same as those used for calculating the energy balance.

The environmental releases associated with collection and separation are local issues, whereas releases associated with transport to remanufacturing facilities (which might even be outside the United States) and emissions from remanufacture are distant effects. Local and distant emissions are covered separately in this subsection.

Community Environmental Releases

Releases associated with recycling include the greater emissions that result from multiple pickups in both packer trucks and multi-compartment trucks instead of a single collection of MSW, as discussed under "Energy Requirements." In the estimates given in Exhibit II, the packer truck emissions have been adjusted downward to reflect the results of collecting smaller quantities of MSW at each stop.

Other environmental releases result from operating the MRF; they include truck traffic, noise, dust, and odors. When the recycled materials are diverted from a landfill, however, emissions from the landfill may decrease, and less land space will be required. If the recyclables are diverted from combustion, emissions and ash from the MSW combustor may be reduced. The data base takes these potential reductions into account.

Emissions from Remanufacture

The environmental releases that are eliminated by avoiding mining, harvesting, and extracting raw materials and the impact of recycling on land use are typically included in analyses of recycling. Those issues are beyond the scope of this project, but results of past "cradle-to-grave analyses" are presented in Table 7.4. The bases from which these reductions were estimated are unclear; the reductions may well assume emission levels that are higher than current standards or practice. New analyses of newsprint and glass now under way at Argonne National Laboratories should update and expand the data presented here.

INTEGRATED SYSTEM EXAMPLE: CURBSIDE COLLECTION OF RECYCLABLE MATERIAL, SEPARATION IN AN MRF, RECYCLING WITH LANDFILL OF THE REMAINING MSW

To illustrate the application of the data on technologies to the evaluation of options for an integrated MSW management strategy, this section summarizes the energy balance and air and water emissions for:


                                 Table 7.4
BENEFITS FROM USING RECYCLED MATERIALS IN PLACE OF VIRGIN MATERIALS(a)

                                  Benefit
                               (% reduction)

                  Aluminum         Steel          Paper          Glass

Energy                  90                47-74            23-74             4-32
Air pollution           95                85               74                20
Water pollution         97                76               35                 -
Solid waste(b)          90                 -                -                80


Sources: All except solid waste--Appendix E, page E-55; Robinson
         (1986), cited in Thurner and Ashley (1990).

(a) These data are old and fragmentary, and they may refer to in-plant
    savings alone.
(b) Source: Sellers and Sellers, 1989.

Click here for table in WK1 format.


Table 7.5 shows the energy and emissions over a 20-year period from adding MRF operations and recycling to a strategy that involves landfilling alone. The estimates in the table include energy and emissions for normal collection of MSW, energy recovered from the landfill gas, and landfill emissions and leachate along with the energy and emissions associated with the curbside collection and MRF processing of recyclables. Credits for energy savings that result from actually recycling the separated materials through remanufacture are also included. The results are given separately for transportation, processing (MRF operations), and disposal (landfilling the nonrecyclable materials). Table 7.6 presents the same data for the landfill strategy.

Energy requirements and air emissions for curbside collection depend on the efficiency of truck use. In the example considered here, separate collection of recyclables required a few smaller trucks, and the net result was an increase of 20% in the collection energy requirement. In the community used as the model for this integrated strategy example, the small recycling trucks used for curbside collection were repeatedly filled to capacity before they returned to the dropoff point.

Although the total energy saved by adding curbside collection and recycling was less than the energy recovered from the landfill, it was 10-20 times as great as the quantity of energy required by the community for collection and processing. Unless the collected materials are recycled in the community, the energy savings will benefit other areas (or the U.S. economy as a whole) rather than the jurisdiction that is conducting the program.


                                               Table 7.5
   ENERGY AND EMISSIONS FOR STRATEGY 6: CURBSIDE COLLECTION WITH MRF AND LANDFILL

                                Total  Collection  Process(a)   Disposal
Landfill space (assuming a depth
of 50 feet), 10(-5)acres               1.82                                1.82
Energy Required (million Btu)         0.116       0.094        0.02       0.002
Energy Produced(million Btu)           2.80        0.00        0.80        2.00
Net Energy (million Btu)               2.68       -0.094       0.08        2.00

Air Emissions
Particulates (lb)                      0.02        0.02
Carbon Monoxide (lb)                   0.94        0.94
Hydrocarbons(lb)                       0.09        0.09
Nitrogen oxides (lb)                   0.38        0.38
Carbon dioxide (lb)                    397                                 397
Water (lb)                             171                                 171
Methane (lb)                          13.05                               13.05
NMOC (lb)                              0.68                                0.68

Dioxin/furan {10(-6)lb}(2)
SO(2) {10(-3)lb}
HCI {10(-3)lb}

Antimony {10(-6)lb}
Arsenic {10(-6)lb}
Cadmium {10(-6)lb}
Chromium {10(-6)lb}
Lead {10(-6)lb}
Mercury {10(-6)lb}
Nickel {10(-6)lb}
Zinc {10(-6)lb}
Total Heavy Metals {10(-6)lb}           NA                                  NA

Effluent
Leachate (gal)                        72.80                               72.80
Leachate (lb)                          607                                 607
Chloride(lb)                           1.03                                1.03
Sodium (lb)                            0.66                                0.66
Potassium (lb)                         0.56                                0.56
COD (lb)                               0.15                                0.15

Arsenic {10(-6)lb}                      78                                  78
Cadmium {10(-6)lb}                     2.7                                 2.7
Chromium {10(-6)lb}                    148                                 148
Copper {10(-6)lb}                       39                                  39
Nickel {10(-6)lb}                       98                                  98
Lead {10(-6)lb}                         44                                  44
Mercury {10(-6)lb}                     5.4                                 5.4
Zinc {10(-6)lb}                         NA                                  NA
Total Heavy Metals {10(-6)lb}          416                                 416
AOX                                    0.98                                0.98

(a) Curbside MRF and recycling.

(b) This is total dioxin/furan as specified by EPA in CFR, 1991a.

Click here for table in WK1 format.



                                   Table 7.6
   ENERGY AND EMISSIONS FOR STRATEGY 1: LANDFILL WITH GAS RECOVERY

                                Total   Collection  Process   Disposal
Landfill space (assuming a depth
of 50 ft), 10(-5) acres                2.00                                2.00
Solid waste (lb)                       2000                                2000
Energy Required (million Btu)         0.081       0.079                   0.002
Energy Produced (million Btu)          2.20         0                      2.20
Net Energy (million Btu)               2.12       -0.079                   2.20

Air Emissions
Particulates (lb)                      0.02        0.02
Carbon Monoxide (lb)                   0.79        0.79
Hydrocarbons (lb)                      0.08        0.08
Nitrogen oxides (lb)                   0.32        0.32                     NA
Carbon dioxide (lb)                    225                                 225
Carbon dioxide—combustion (lb)         212                                 212
Water (lb)                             188                                 188
Methane (lb)                          14.34                               14.34
NMOC (lb)                              0.75                                0.75

Dioxin/furan {10(-6)lb}(a)
S0(2) {10(-3)lb}
HCI {10(-3)lb}

Antimony {10(-6)lb}
Arsenic {10(-6)lb}
Cadmium {10(-6)lb}
Chromium {10(-6)lb}
Lead {10(-6)lb}
Mercury {10(-6)lb}
Nickel {10(-6)lb}
Zinc{10(-6)lb}
Total Heavy Metals {10(-6)lb}           NA                                  NA

Effluent
Leachate (gal)                          80                                  80
Leachate (lb)                          667                                 667
Chloride (lb)                          1.13                                1.13
Sodium (lb)                            0.73                                0.73
Potassium (lb)                         0.60                                0.60
COD (lb)                               0.16                                0.16

Arsenic {10(-3)lb}                      86                                  86
Cadmium {10(-3)lb}                      3                                   3
Chromium {10(-3)lb}                    163                                 163
Copper {10(-3)lb}                       43                                  43
Nickel {10(-3)lb}                      108                                 108
Lead {10(-3)lb}                         48                                  48
Mercury {10(-3)lb}                      6                                   6
Zinc {10(-3)lb}                         NA                                  NA
Total Heavy Metals {10(-3)lb}          457                                 457
AOX (lb)                               1.08                                1.08


(a) This is total dioxin/furan as specified by EPA in CFR, 1991a.

Click here for table in WK1 format.


In comparison with landfilling alone, the strategy that includes recycling increases air emissions for the collection step, but decreases the emissions from the landfill. Water emissions from the landfill also decrease by about 10%, for a net reduction in water emissions.

Few data on collection distances and loadings per trip have been published. The data used in this example were collected by SRI International from community officials of an affluent residential/ commercial community in California that has had an active program for curbside collection of recyclables for more than 12 years (City of Palo Alto, 1991). The data should be considered illustrative only; additional examples are needed to draw reliable conclusions.

Details of the calculations used to obtain estimates of emissions and energy consumption are presented in Exhibit II. The computerized version of the data base allows a user to change the collection amounts and mix of collected materials, to substitute other measures of collection efficiency for those used in this report, and to enter the actual miles traveled.

OTHER INTEGRATED STRATEGIES DESCRIBED IN THE DATA BASE

The computerized data base also allows the user to analyze the effects of integrating separation and recycling with any of the other technologies in an integrated MSW management strategy. Calculations for the following integrated strategies that include collection, separation, and recycling or on-site separation and recycling have already been performed and are included in Exhibit II and in the computerized data base:

Calculations are also provided for the following less commonly used integrated strategies that add separate collection of yard waste for composting to the strategies that involve collection and separation of recyclables:

On-site separation of recyclables from MSW (which does not require collection of recyclables separated by the waste generators) is covered in two additional strategies:

Missing or Limited Data and Research Needs

-OR-

Table of Contents